Adjustable jewelry really gives a new meaning to One Size Fits All. Our NEW slide clasps will give you the ability to customize your own adjustable jewelry.
This blog will cover the two types of clasps and compatible chain, perfect for making adjustable jewelry. Plus, a tip on how to get your chain through the slide clasps.
Slider Clasp and Slide on Clasp
We have two types of slider clasps.
- Two Hole Slider Clasp: This will allow chain to run through the holes parallel to each other.
(Item#: Z011948, Z011951, Z011952)
2. Slide on Clasp with Hole for Jump Ring: This clasp has a hole on the side that you can attach a jump ring and chain. You will typically use two Slide on Clasp, two pieces of chain and two jump rings. The chain will run parallel and in opposite directions.
(Item#: Z010758, Z010759, Z010769)
It’s best to use size 4mm oval or round jump ring: A002413, A011517, Z001661, Z001662.
Compatible Chain
The best chain to use with these slider clasps are small dainty chains between 1.8mm and 2.2mm in size. The following chains will work with the slider clasps:
- A008135 / CH01090 / CH01194 – 2mm Rollo Chain
- CH00533 / CH00532 – 2.2mm Soldered Cable Chain
- A008118 – 2.2mm Silver Plated Ornate Chain
- A008131 /A008132 – 7mm Bar Chain
However, we would recommend using the Two Hole Sider Clasps with 2mm Rollo Chain and 2.2mm Soldered Cable Chain. And all chain recommendations can be used with the Slide on Clasp with Hole for Jump Ring.
Chain and Clasp Tip
There is a silicone ring inside each hole of the slider clasp. This allows the chain to slide and make your jewelry adjustable. To get your chain through, we have two suggestions for you:
- Use a 2 inch piece of wire and make a small loop at one end and attach your chain to the loop. Use this makeshift needle to sew through hole clasp, and pull your chain through.
- Or if you are using a very thin wire, fold your 2 inch piece of wire in half, slide your chain end through to the middle section of the wire and use both end of the wire to sew through hole clasp.
What size beads would these chains take?
You’ll need beads with at least a 2.5mm hole. I would suggest the Large-Hole Interchangeable Beads and Petite Interchangeable beads. I would also suggest Large-Hole Gemstone beads.
I am not seeing how V. 2 is adjustable as shown. What am I missing?
Thanks
It’s adjustable when you add two Slide on Clasp. On the other ends of your chain, you will add your design and the adjustable part slides in both direction to expand the necklace.
Can these be used for beaded bracelets too? Or only for necklaces?
It can be used for beaded bracelets, yes!
Hello .. would these be compatible with beading strings etc for example S-lon or Chinese knotting cord? Thank you
Yes they would be good for knotting cord. S-long might be a bit small for these clasps. If you are using thinning thread, you can use the 4x5mm and cross the cord ends through the slider claspL Z008577 or Z008576
Let us know if you have more questions.