Look your best with a DIY Rhinestone Chain Bracelet with an adjustable sliding clasp. Here are items you’ll need to make your own:

• 1 foot of 4mm Rhinestone Chain – CH00238 (Gold CH00239)
• 2 – 4mm Rhinestone Chain End Connector – Z008775 (Gold  Z008785)
• Silver Rollo Chain Bracelet Sliding Clasp – Z012151 (Gold Z012152)
• Flat Nose Pliers
  Or
• Optional: Nylon Pliers or Serrated Pliers

Directions:

1. Cut rhinestone chain to consist of 18 -20 rhinestones.
2. Cup the last rhinestone with the end connector.
3. Using flat nose pliers, nylon pliers or serrated pliers, gently push down the two prongs of the end connector to secure chain end.
4. Repeat Step 3 to other chain end.
5. Open both jump rings on the adjustable bracelet sliding clasp and set aside.
6. Cut 2 inches off  both open ends of the sliding clasp chain. (This will shorten your bracelet sliding clasp.)
7. Slide back on the jump ring onto the sliding clasp chain and through a loop of the end connector. Close jump ring.
8. Repeat Step 7 to other sliding clasp chain end and end connector.