Easy DIY Chain Bracelets

Today’s tutorial demonstrates how easy making simple bracelets can be. Simple and dainty with only three components; chain, jump rings and lobster clasp.

What you’ll need:

• Chain – Item used in samples CH01040, CH00995 & CH00800
• 4mm Jump Rings – Z011500
• 5mm Split Ring – Z001368
• Lobster Clasp – Z001124
• Split Ring Pliers – FTTL0006

Directions:

1. Measure chain to wrist size and then cut a link short of your measurement.
2. Open 4mm jump ring, slide on one end of chain end and through lobster clasp. Close jump ring.
3. Gently open split ring with a split ring pliers (FTTL0006) and slide split ring through other end of chain.
   Note: If you find that your bracelet is a bit long, take off clasp end, cut another chain link off and reattach lobster clasp. If you find that your bracelet is short, add another split ring with a 4mm jump ring to the first split ring you attached to the chain.
4. Repeat all steps for other bracelets.