DIY Golden Turquoise Wrap Bracelet

Design this fancy Golden Turquoise Wrap Bracelet with memory wire, Czech beads, Swarovski® crystals, cork cord and curve tube with loop.

What you’ll need to make bracelet:

• 5mm Cork Cord – CH00881 (16 Inches)
• 5mm Gold Cord End – Z006380 (8 pieces)
• Gold Memory Wire – WR00126
• 9x6mm Czech Rondelle – Item in bracelet Z011353
• 8mm Swarovski Briolette Beads – Item in bracelet SW02236 (12 pieces)
• 10mm Gold Wavy Disc – Z018416 (5 packs)
• 6mm Gold Wavy Disc – Z018412
• 50mm Curve Tube with Loop – Z011737 (2 pieces)
• 5mm Gold Jump Ring – A011519
• 11mm Antique Gold Ethnic Dart Drop Charm by TierraCast – TC02440
• Tassel with Gold Cap – Item in bracelet Z013767

Directions

1. Make a coiled loop at one end of the memory wire with Memory Wire Finishing Pliers.
2. Cut cork cord into 4 pieces, measured at about 4 inches.
3. Slide the following sections onto the memory wire:
   a. End cap, cork piece and end cap.
   b. Czech Bead, TWO 10mm wavy discs (one concave in and the other concave out). Repeat 5 more times (omitting the last 2 wavy discs).
   c. TWO 6mm wavy disc (one concave in and the other concave out), THREE crystals, TWO 6mm wavy disc, THREE crystals, TWO 6mm wavy disc.
   d. Repeat Step 3b.
   e. End cap, cork piece, end cap, curve tube with loop, end cap, cork piece and end cap.
   f. TWO 6mm wavy disc, THREE crystal beads and TWO 6mm wavy disc.
   g. Czech Bead, TWO 10mm wavy discs (one concave in and the other concave out). Repeat 11 more times (omitting the last 2 wavy discs).
   h. TWO 6mm wavy disc, THREE crystal beads and TWO 6mm wavy disc.
   i. Curve tube with loop, end cap, cork piece and end cap.
4. Cut memory with Memory Wire Cutters leaving half an inch end. Coil and make a simple loop.