Dot & Dash Fringe Earrings

Today’s tutorial is a revision of popular DIY Golden Fringe Earrings we did a few weeks back. Our Dot & Dash Fringe Earrings is on another level of gorgeous!

What you’ll need for earrings: (Silver alternative available)

• 8 Feet – CH01037 or CH01036
• 1 pair – Z001831 or Z001829 (or make them bold with Z016060)
• Jump rings – A011517 or Z011500
• 20mm Medium Slide End Tube – Z011023 or Z009111

Directions:

1. Cut chain at these lengths and alternate the dots and dashes
   7 inches – Dash at beginning and end
   6 ¼ inches – dot at beginning and end
   5 ¾ inches – dash at beginning and end
   5 inches – dot at beginning and end
   4 ½ inches – dash at beginning and end
   3 7/8 inches – dot at beginning and end
   1 ½ inches – dash at beginning and end
   1 ½ inches – dot at beginning and end
   1 ¾ inches – dash at beginning, dot at end
   1 ¾ inches – dot at beginning, dash at end
   1 ¾ inches – dash at beginning, dot at end
   1 ½ inches – dot at beginning and end
   1 ½ inches – dash at beginning and end
2. Slide what you’ve cut in Step 1, in the same sequence through the slide end tube.
3. Slide the end of 3 7/8 inches through end tube.
4. Slide the end of 4 ½ inches through end tube.
5. Slide the end of 5 inches through end tube.
6. Slide the end of 5 ¾ inches through end tube.
7. Slide the end of 6 ¼ inches through end tube.
8. Slide the end of 7 inches through end tube.
9. Close side tab of end tube with a flat edge, like pliers.
10. Open jump ring and slide on loop of end tube and ear wire loop. Close jump ring.
11. Repeat all steps for other earring.