DIY White Valentine’s Heart Bracelet with Leather

Valentine’s Day is around the corner, which makes this leather bracelet fitting for the occasion. Made with 2mm leather cord and silver findings and beads, you’ll fall in love with how easy it is to make!

Items used in leather heart bracelet:

• Z009203 (4) – Hearts Around Bead for 2mm Leather
• X005968 (4) – Petite Heart Connect Bead
• Z012736 (2) – Antique Silver Crescent Slider for 10mm Flat Leather
• A015688 – Antique Silver Small Magnetic Clasp for Flat Leather
• Z002563 – Antique Silver Heart Shaped Slider
• A013406 – 2mm White Leather Cord
• E-6000

Directions:

1. Measure your wrist. Subtract an inch off your measurement. Cut 4 pieces of leather at this length.
2. Use a toothpick or swab to add some glue to the inside channel of one side of your clasp. Insert all 4 leather cord ends into this clasp end. Let it dry for a few minutes.
3. Slide all 4 cord ends into the crescent slider, concave out. Slide a heart bead onto each cord. Use 2 Heart Around and 2 Petite Heart.
4. Slide all four cord ends through the Heart Shaped Slider.
5. Slide a heart bead onto each piece of cord. Use 2 Heart Around and 2 Petite Heart. Slide a all 4 cords into the 2nd crescent slider bead, concave in.
6. Lay your leather and beads down and try to straighten your pattern. Flush other leather ends. Make a flush cut if necessary.
7. Add glue to other channel of clasp and insert all 4 leather ends. Let bracelet dry for at least 24 hours.

Designed by Jacque.