DIY Flora Link Criss Cross Leather Bracelet with Macrame Knots

We love the contrasting colors in this Flora Link Cross Cross Leather Bracelet. This DIY uses a braided and macramé technique using round leather cord and TierraCast Flora Links. It’s also a revamp version of the Criss Cross Leather Bracelet we did back in May.

What you’ll need for Leather Bracelet:

• Z015514 – 1mm Natural Light Brown Leather
• A022077 – 2mm Natural Blue Leather
• TC02377 (2) – Small Flora Link
• TC02379 (3) – Medium Flora Link
• TC02349 – Button

Get all the components for this project here

Directions:

1. Cut 30 inches of the 2mm leather cord.
2. Cut 60 inches of the 1mm leather cord.
3. Slide 2mm leather through button and center it. Take both leather ends and make a knot an inch away from the button.
4. You can use a macrame board to anchor your 2mm leathers down or pin it down to anchor it also.
5. Slide the middle part of your 1mm leather behind both of the 2mm leather cord, near the knot you made in Step 3. Make 7 full square macramé knots.
6. Slide on a small flora link. In front of the link cross the left piece of the 1mm over the 2 strands of 2mm cord and then cross the right piece over the left peice.
7. Take the both ends of 2mm leather and bend them back over the crisscrossed strands and go back thru the ring. Tighten, adjust and straighten your strands.
8. Repeat steps 6 and 7 with a sequence of 3 medium flora link and 1 small flora link.
9. After last ring do 7 FULL macramé square knots.
10. With all 4 pieces of cord make an overhand knot where the macramé ends. Trim ends of the 1mm cord.
11. Make another overhand knot with both leather ends about one inch from the first to create your button hole clasp. Make another for an optional length.

Video Tutorial

Check out our previous Facebook LIVE episode where Tory makes this bracelet HERE!