Gemstone Ripple Necklace

Get lost in this mesmerizing DIY necklace with DakotaStones Gemstone Ladder Pendant set and Adjustable Necklace Sliding Clasp.

What you’ll need to make Gemstone Ripple Necklace:

• Silver Necklace Memory Wire (WR00134)
• Adjustable Necklace Sliding Clasp (Z011945)
• Gemstone Ladder Pendant Set: MLTPYR15-38-LAD-PEN
• 20 Gauge Artistic Wire (AW00007)

Directions:

1. Cut necklace memory wire at 1/3″ of a coil with Memory Wire Shears.
2. With Memory Wire Finishing Pliers, curl one end of your memory wire inwards, towards curve of your memory wire to make a simple loop.
3. Slide on the sequence of your gemstone ladder set.
4. Make another simple loop to the other end of your memory wire.
5. Center gemstone set in the middle of the memory wire.
6. With the 20 Gauge Artistic Wire, wrap 4 coils around the memory wire, on each end of the pendant set. Cut excess wire.
7. Use crimping pliers to crimp the coils in Step 6 to keep coils and pendant set in place.
8. Open jump ring on necklace sliding clasp and slide through one loop of memory wire. Close jump ring. Repeat to other jump ring and other memory wire loop.

Design necklace with these other 11 Piece Gemstone Ladder Pendant Sets. 

Pendant Set Item Numbers: LAPLGIM15-38-LAD-PEN, PPLBRZ15-38-LAD-PEN, RCJ15-38-LAD-PEN, ORIM15-38-LAD-PEN, LAPBRZ15-38-LAD-PEN, TQSBRZ15-38-LAD-PEN, MLTPYR15-38-LAD-PEN, PKBL15-38-LAD-PEN, MGI-FAN-PEN-11